Sears Clothes Dryer owner manual Installing coin-slide mechanism, Coin box adjustment

Installing coin-slide mechanism

NOTE: If the coin-slide mechanism is installed, skip this step and proceed to coin-box adjustment.

Remove the service door from the meter case by unlock- ing the service lock with the key shipped with the dryer. Carefully insert coin-slide mechanism into opening and

guide into holes. Secure the coin slide with bolt from inside the meter case.

NOTE: Removing timer from mounting screws may facilitate inserting the bolt.

Replace the service door. Be sure the lock is located toward the rear of the case.

Coin box adjustment

The tight fit of the money box is set at the factory.

Customer may loosen fit as desired by loosening the slotted nuts.

Keep a record of all coin-box key numbers. A lost key can only be replaced if ordered by key number from Sears Parts. The key number is located both on the key and behind the end panel of the coin box. If the key number is not available, the lock must be drilled out to remove the coin box.

Replace meter-case access panel.

Final installation connection

1.Connect exhaust vent to exhaust outlet of the dryer.

2.Carefully move dryer into permanent location. Provide at least the minimum installation clearances

between dryer and rear wall. See the chart. This will ensure you have an adequate clearance for service

and proper operation and that you have sufficient distance from combustible construction.

3.Plug in dryer or connect power.

Starting the dryer without using the coin mechanism

1.Close the dryer door.

2.Push the PUSH TO START button firmly.

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating. Failure to do so can result in death or electrical shock.

3.If the dryer does not start, remove the meter-case service door.

4.Push the ratchet arm towards the rear of the dryer until it stops, then release.

5.Replace the meter-case service door. Be sure the lock is located toward the rear of the case.

6.Push the PUSH TO START button firmly.

Arm

13