There are two motor safety filters: 1. a dark foam filter incorporated in the red frame and
2.a white electrostatic filter that is laid on the back side of the dark foam filter,
These filters should be checked with each bag change. The dark foam filter can be washed,
per the instructions below and the white filter must be replaced when dirty.
WARNING
3.Peel the white filter off the dark foam filter as
Electrical Shock Hazard
Do not operate the cleaner without the motor safety filter. Be sure the filter is dry and properly installed to
prevent motor failure and/or electrical shock.
1. Unplug cord from wall outlet
and remove bag.
2. Pull out safety filters as shown.
shown. Lay a new White
Etectroste#c
white filter on the Filter dark filter by align-
ing the notches in DmrkFoam
the filter with the Filter
The new filter can be purchased under part number 4369971 at your local Sears Service Unit,
Toll Free Number
DARK FOAM FILTER
This filter and the frame can be washed in warm soapy water, rinsed and air dried. DO
NOT clean in a dishwasher or clothes
washer or install while damp.
WHITE ELECTROSTATIC FILTER
This filter must be replaced when dirty. It
should be replaced regularly depending on use conditions. The filter CANNOT be
washed as it will lose its dust trapping ability.
4.Snap filter back into canis-
ter.
5. Insert bag.
Unplug cord from wall outlet. Do not drip water on cleaner.
Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe dry after cleaning.
To reduce static electricity and dust build- up, wipe outer surface of cleaner and attachments.
Wash attachments in warm soapy water,
rinse and air dry. Do not clean in dish- washer.
DO NOT USE ATTACHMENTS IF THEY ARE WET.
CAUTION
Attachments used in dirty areas, such as under a refrigerator, should not be used on other surfaces until
they are washed. They could leave marks.
13
