Sears L0711256 owner manual To Replace Belt, Brush Support, Remove worn, Cover Base

5.Carefully insertand twist

screwdriver at each brush

supportto freebrush

frombase.

. Base

Brush

Support

6. Remove worn

belt.

TO REPLACE BELT:

t. Slide washers and brush supports onto brush assembly.

7. Slide brush

supports off to check and clean brush support areas. See

BRUSH ASSEMBLY for picture of complete brush assembly.

2.Install new belt over motor

drive, then over brush

sprocket.

NOTE: See

PARTS AND FEATURES for Belt #.

4.Line up front of cover

and base. Rest cover

on front edge of base as shown.

Brush

Brush Brush Sprocket Support

3.Snap brush supports into place on base. Be sure brush

supports are not upside- down.

Cover Base

5.Tilt cover to back. Press

cover firmly until side tabs snap

into place.

Replace cover screws, light bulb and light

cover.

15