Sears L0711256 To Remove Belt, Push, Turn, Screws, Qlck cover forward Re/ease from back until

Always follow all safety precautions when cleaning and servicing the POWER-MATE TM.

Electrical Shock Or Personal Injury

Hazard

Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in elec- trical shock or personal injury from cleaner suddenly starting.

1.Remove light

cover by pressing in and lifting both sides as shown.

Push In		_	2. Push in and turn
And Turn		r_	bulb counterclock-
	_		wise to remove.				bulb.
			3. Replace		the
_"%	_		Bulb must		not	be
			higher	than	15 Watts.
	_---_'_		Close	light	cover until
			it snaps in place.

NOTE: See PARTS AND FEATURES for Bulb #.

Disconnect cleaner from electrical outlet. Check and remove hair, string and lint build- up frequently in the POWER-MATE TM brush and brush support areas. If build-up becomes excessive, disconnect POWER- MATE TM from wand and follow the steps below. Instructions can also be found under the light cover.

TO REMOVE BELT:

1. Remove light

cover and light bulb as shown

under LIGHT

BULB

CHANGING.

2. Unscrew the

POWER-

MATE TM cover

screws.

3.Turn

POWER-

MATE TM over.

To remove

cover, insert screwdriver at cover tabs on both sides and twist to release tabs.

4. Turn POWER- MATE TM right side up. Press handle release

pedal and lower the swivel. Tilt

Q_lck cover forward

Re/ease from back until

front snaps free.

14