Sears NTL61011.1 Assembly, Make sure that the power cord is unplugged, Age the Upright Wire

ASSEMBLY

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

•The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex keys one adjustable wrench one Phillips screwdriver scissors needlenose pliers

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.	1
Pull the Upright Wire (70) and the Base Ground
Wire (92) through the indicated hole in the Base
(80).
Remove and discard the indicated screw (A) in
the Base (80). Attach the Base Ground Wire (92)
to the Base with a #8 x 1/2" Ground Screw (1).
Press a Base Cap (77) into the Base (80). Make
sure that the Grommet (67) is pressed into the
square hole in the Base.
See the inset drawing. Cut the plastic tie near
the Upright Wire (70). Be careful not to dam-
age the Upright Wire.

	Hole	67
77
	92
	1
	A	80	Tie
70			Cut
			70

7