ENFORCER DNR / DWDR / IR NVD Bullet Camera with
Overview: | Sunshield | Mounting screw |
| ||
|
| |
|
| Hex screw |
Rubber grommet
|
| ||
Zoom | Service | Mounting base | |
Focus | monitor port | ||
| |||
|
| ||
Connect | OSD joystick | ||
service monitor | |||
port connector |
|
| |
Mounting plate
BNC connector
DC Jack DC plug with terminal block
Important:
Do not cut DC jack or BNC connector as warranty will be voided.
Before Starting:
1.Please read this manual carefully and keep it for future reference.
2.Use the camera within given temperature and electrical limits.
3.Do not aim the LEDs directly at the eyes when the LEDs are on.
4.Do not point the camera at the sun. Heat could damage the camera, even when not in use.
5.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.
6.Do not open or disassemble the camera. There are no
7.Do not drop the camera or subject it to strong vibrations.
Installation:
1.Run a 12VDC or 24VAC power supply wire and a video cable with a male BNC connector through the wall to where the camera is to be mounted.
2.Temporarily connect the camera to the power supply. Do not cut the DC jack or the female BNC connector as the warranty will be voided. If needed, use the included
3.Connect the included service monitor port connector to the service monitor port.
4.Connect the service monitor port connector’s BNC to a test monitor.
5.While watching the monitor, hold the camera against the wall or ceiling by hand where it is to be mounted, then turn the camera until it is certain that this mounting location is correct. Use a pencil to mark the location of the four screw holes in the mounting plate.
6.Mount the mounting plate and rubber grommet to the wall or ceiling using the four included mounting screws. If the wall is made of drywall, brick, or similar material, it may be necessary to use screw anchors (not included).
7.Mount the camera base to the mounting plate using the four included hex screws.
8.Adjust the camera angle. See
Arm” on page 2.
9.Adjust zoom and focus by moving the zoom and focus knobs on the side of the camera. Then use the OSD control joystick to adjust camera settings. (See OSD manual).
10.Disconnect the power supply and service monitor connector.
11.Put the sunshield on the camera.
12.Do a final test of the video camera and monitor.
3 |
