SECO-LARM USA SLI 762FP-ISS owner manual Introduction, How It Works, Personal Id Number Pin

INTERNAL

SECURITY

SYSTEM

TOUCHKEY IMMOBILIZER SLI® 762FP-ISS

OWNERS MANUAL

INTRODUCTION

Congratulations! Your vehicle is now protected by the SLI 762FP-ISS. This Touchkey Immobilizer is designed to be used with almost any vehicle.

The Touchkey Immobilizer combines high security with the convenience of completely automatic arming.

To disarm and operate the vehicle, insert the Touchkey, remove it, and start the engine. No other buttons to push, no codes to remember. When the destination is reached, turn the engine OFF. 30 seconds later, the engine is automatically and completely disabled.

HOW IT WORKS

When the Touchkey is inserted into the receptacle, the Immobilizer reads the key’s code. If the Touchkey was properly coded to the system, the Immobilizer disarms, allowing the engine to start as normal.

However, the engine won’t start if someone tries to start it without the Touchkey. Only Touchkeys properly learned by the system can start your engine!

PERSONAL ID NUMBER (PIN)

Included with the SLI 762FP-ISS is a small card with a secret PIN. This 3-digit number is required to enter the valet mode, do emergency disarm, or add new Touchkeys.

DO NOT LOSE THE CARD. KEEP IT IN A SAFE PLACE.

For information on valet, emergency disarm, or code learning new Touchkeys, see page 2.

LED INDICATOR

The LED indicates the following:

1.Armed – While unit is armed, the LED flashes.

2.Arming – While unit is arming, the LED flashes rapidly.

3.Disarmed – While the unit is disarmed, the LED is OFF.

4.Triggered – If you try to start the engine without the Touchkey, the LED will show steady ON.

5.Code learning – The LED will show steady ON to indicate a new Touchkey has been successfully learned.

6.Valid code entered – If a valid PIN number or programming code is entered, the LED will flash rapidly for three seconds.

7.Valet/override – When the Immobilizer is in the valet/override mode, the LED will flash 11 times, then flash slowly when the ignition is turned OFF. The LED will turn OFF when the ignition is turned ON.

DISARMING THE SYSTEM

1.Normal disarm – Insert the Touchkey into the receptacle and remove it. Start the engine within 30 seconds. If the engine is not started within 30 seconds, the Immobilizer will automatically rearm.

2.Emergency disarm – If the Touchkeys are lost, use the secret PIN to put the unit into valet/override mode (see page 2).

ARMING THE IMMOBILIZER

1.Arming procedure:

a.Turn the ignition switch OFF.

b.30 seconds later (unless you turn the switch ON again), the unit arms, and the LED flashes slowly.

2.Re-starting the engine:

a.Within 30 seconds of turning the ignition OFF – Start the car normally.

b.30 seconds or more after turning the ignition OFF – Go through the disarming procedure again (see above).

SECO-LARM ®