Sega DLX owner manual Accelerator & Brake, Adjustment and Replacement of Volume

Volume Page 1 of 2

[Table of Contents] [Previous Page] [Next Page]

10. ACCELERATOR & BRAKE

In the test mode, if the ACCEL. & BRAKE V.R. value is not within the allowable range, an adjustment of V.R. installation position, or a replacement of V.R. is needed. Also, grease the MECHA's shafts and sliding portions once every 3 months.

When performing the above work, take off the 4 truss screws and remove the front cabi's front lid.

10-1 ADJUSTMENT AND REPLACEMENT OF VOLUME

FIG. 10.1

The ACCEL. & BRAKE MECHA can be seen by removing the front lid. The ACCEL. V.R. is on the left- hand side and the BRAKE V.R. is on the right-hand side of the MECHA. Check the V.R. value in the test mode. The appropriate value of each V.R. is as follows:

When released:		When stepped on:
ACCEL.: Under 2 DH	<--->	Over D3H
BRAKE: Under 2 DH	<--->	Over D3H

Method of V. R. replacement

To replace the V.R., after taking off the connector from the V.R. to be replaced, take out the 2 screws which secure the VR BRACKET, and remove the V.R. together with the bracket and gear. After the replacement, check the V.R. value variations in the test mode.

http://www.sauservice.com/manuals/Daytona%20Folder/DDhtml/DD35.html7/12/2005