CHAPTER 5

5.2.10 CPU and Encoder Board Replacements

See Appendix A for CPU Board tests. Note that removal of the underlying plate does not require removal of these boards for the required access. Only unplug the connectors. Refer to Figure 5-14, and proceed as follows:

Step 1. Remove the Rear Case member (see Section 5.2.1).

For CPU Board:

Step 2. If desired, replace the circuit component(s) most closely related to the problem.

Step 3. If the problem persists, disconnect the board connectors, and remove the four screws holding the Main Circuit Board. Then, remove the board itself. Note: After replacing the CPU Board, perform a Printer Setup (see Appendix A).

For Encoder Board:

Step 4. Remove the four screws and the CPU Board and Encoder Head Connectors. Then remove the board. The Encoder Board has no socketed ICs, making board level replacement the only option.

Figure 5-14. CPU and Encoder Boards.

5-16

980264-001 Rev.B

Page 72
Image 72
The Eltron Company P310 manual CPU and Encoder Board Replacements, CPU and Encoder Boards