The Eltron Company P310 manual Card Feeder Part Removals, Card Feeder Rear

CHAPTER 5

5.2.5 Card Feeder Part Removals

Figure 5-5 shows the fasteners associated with Card Feeder parts. Replaceable items include the Belt, Roller, Motor, or the unit as a whole.

To replace the Belt, slide on a new belt in place of the old.

To replace the Motor, remove belt and the three screws holding the motor, and unplug the motor connector from the Daughter Board.

To replace the Roller, first remove the whole unit. Then, using a small flat tipped screwdriver, pry to release the snap-in tabs holding each end of the Roller Assembly. Drop in a new Roller in place of the old, and return the tabs to their associated slots.

To replace the unit as a whole, remove the two screws and disconnect the spade lug that grounds the anti-static brush. Unplug the motor connector as described for Motor Replacement.

Figure 5-5. Card Feeder Rear

980264-001 Rev. B 5-7