The Eltron Company P310 manual Adjustment Replace Or Cleaning Ment

			CHAPTER 4
Problems Associated with Print Anomalies
Symptom	Possible Causes	References
		Adjustment	Replace-
		or Cleaning	ment
	Non Eltron Ribbon Installed Upside Down	2.2.4	5.2.10
No Image	CPU Board
	Head Up/Dn Motor		5.2.16
	Head Position Sensors		5.2.12
Faint Image	Low Print Head Voltage		5.2.10
	Dirty Print Head	6.2.2
Artifacts	Particles on Feed or Transport Rollers	2.2.7, 6.2.1
Horizontal Lines	Dirty or Damaged Print Head Element	2.2.7, 6.2.2	5.2.6
Multiple
Evenly-Spaced	CPU Board Print Head Registers		5.2.10
Horizontal Lines
Vertical Lines	Stepper Transport Belts Too Tight	6.3.1
Sticking Ribbon	Peel Bar Adjustment	6.3.3
Washout	Peel Bar Adjustment	6.3.3
Sheared Ribbon	Image Not Centered	6.3.2
Image Off Center	X- and Y-Offset Values	6.3.2
CMYK Not	Erratic Card Feed due to Belt Tension or dirty rollers	2.2.7, 6.2.1,
Aligned		6.3.1
	Initialization/Ribbon Sensor/Proper Ribbon	2.2.4	5.2.8
Abrupt Color	Flag Sensor		5.2.13
Change	Clutch Pads		5.2.17
	Ribbon Take-Up Motor/O-Ring		5.2.14

Problems Associated with Card Transport Failures

Symptom	Possible Causes	References
		Adjustment	Replace-
		or Cleaning	ment
	Card Gate Adjustment	2.2.5
No Card Feed	Dirty Card Feed Roller	2.1.5~2.1.7	5.2.16
	Card-Feed Motor
	Card-Feed Belt		5.2.16
Multiple Card Jam	Card Gate Adjustment	2.2.5
Partial Card Feed	Card Transport Belt		5.2.9, 5.2.14
	Card Sensor
Stall near Cleaning	Card Sensor
Roller	Rear Card Transport Belt		5.2.14
Stall Past Platen	Front Card Transport Belt		5.2.9

980264-001 Rev. B 4-3