Brother HE 120 Basic Stitching, EStart sewing, FWhen sewing is finished, cut the thread

SE-BrotherE_sgml.book Page 79 Monday, June 30, 2003 3:44 PM

————————————————————————————————————————————————————

eStart sewing.

•For details, refer to "Starting to sew" (page 49).

•For details on sewing reverse/reinforcement stitches, refer to "Securing the stitching" (page 51).

fWhen sewing is finished, cut the thread.

•For details, refer to "Cutting the thread" (page 52).

■ Changing the needle position

The needle position used as the baseline is different for the straight stitch (left needle position) and the straight stitch (center needle position).

1 2

aStraight stitch (left needle position) b Straight stitch (center needle position)

When the stitch width of the straight stitch (left					3
needle position) is set to its standard setting
(0.0 mm), the distance from the needle position to
the right side of the presser foot is 12 mm
(1/2 inch). If the stitch width is changed (between
0 and 7.0 mm (1/4 inch)), the needle position will
also change. By changing the stitch width and
sewing with the right side of the presser foot
aligned with the edge of the fabric, a seam
allowance can be sewn with a fixed width.
			1
		2.0	5.5	7.0
	0.0

3 4 5 6

2

aStitch width

bDistance from the needle position to the right side of the presser foot

c12.0 mm (1/2 inch) d 10.0 mm (3/8 inch) e 6.5 mm (1/4 inch) f 5.0 mm (3/16 inch)

•For details, refer to "Adjusting the stitch width" (page 56).

Basic Stitching 79