Brother HE 120 operation manual SE-BrotherEsgml.book Page 92 Monday, June 30, 2003 344 PM

SE-BrotherE_sgml.book Page 92 Monday, June 30, 2003 3:44 PM

UTILITY STITCHES ———————————————————————————————————————————

hSelect stitch 3 .

•For details, refer to "Selecting stitching" (page 47).

CAUTION

●When using zipper foot "I", be sure to select the straight stitch (center needle position), and slowly turn the balance wheel toward you to check that the needle does not touch the presser foot. If a different stitch is selected or the needle hits the presser foot, the needle may bend or break.

iSew the zipper to the piece of fabric with the extra 3 mm (1/8 inch), starting from the base of the zipper.

CAUTION

●When sewing, be sure that the needle does not touch the zipper, otherwise the needle may bend or break.

jWhen you are about 5 cm (2 inch) from the end of the zipper, stop the sewing machine with the needle lowered (in the fabric), raise the presser foot lever.

kOpen the zipper and continue sewing.

lClose the zipper, turn over the fabric, and then baste the other side of the zipper to the fabric.

1

aBasting stitching

mAttach the presser foot holder to the other pin of zipper foot "I".

If the presser foot holder was attached to the right pin in step g, change it to the left pin.

1

I

2

aPin on the left side b Needle drop point

92