Brother HE 120 operation manual Thread is cut to a suitable length, LPress Start/stop button once

SE-BrotherE_sgml.book Page 20 Monday, June 30, 2003 3:44 PM

GETTING READY ————————————————————————————————————————————

Memo

zWhen using thread that winds off quickly, such as transparent nylon thread or metallic thread, place the spool net over the spool before placing the spool of thread onto the spool pin.

If the spool net is too long, fold it to fit the size of the spool.

1

4

3

2

aSpool net

b Spool c Spool pin d Spool cap

hPull out some thread, and then thread the thread guide for bobbin winding.

Be sure that the thread is fully in the two thread guides for bobbin winding.

1

2

a Thread guide for bobbin winding b Two slits

iWindbobbin.the thread that was pulled out onto the Wind the thread that was pulled clockwise five or six times without any slack.

jPull the thread to the right and pass it through the slit in the bobbin winder seat.

1

aSlit in bobbin winder seat (with built-in cutter)

XThe thread is cut to a suitable length.

CAUTION

●Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out.

kSlide the sewing speed controller to the right (so that the speed will be fast).

1

aSewing speed controller

lPress (Start/stop button) once.

1

aStart/stop button

•If it does not start when the start/stop button is pressed, an animation is displayed on the LCD. Press the start/stop button after touching the LCD.

20