Brother HE 120 operation manual When embroidering, go to e

SE-BrotherE_sgml.book Page 28 Monday, June 30, 2003 3:44 PM

GETTING READY ————————————————————————————————————————————

•If the needle is not raised to the correct posi- tion, the needle cannot be threaded with the needle threader. Be sure to check that the thread cassette indicator is lit up in green before inserting the thread cassette.

bInsert the thread cassette into the thread cassette compartment.

Slowly press down on the thread cassette until it clicks into place.

1

1

aNeedle bar thread hooks

XAt the same time that the thread cassette is inserted, the needle is threaded.

XThe thread cassette indicator goes off.

•If the needle could not be threaded or the thread was not passed through the needle bar thread hook, refer to "Loading the spool into the thread cassette" (page 24) and perform the procedure again starting from step b.

•The thread cassette can be inserted whenever the presser foot lever is raised or lowered. However, when the side cutter is attached, be sure to lower the presser foot lever before installing the thread cassette. For more details, refer to "Sewing overcasting stitches using the side cutter" (page 76).

CAUTION

●The needle threader will automatically thread the needle when the thread cassette is pushed down. Be sure to keep your hands and other items away from the needle, otherwise injuries may occur.

cCarefully pull on the loop of thread passed through the eye of the needle to pull out the end of the thread.

a Push here

• When embroidering, go to e.

28