Brother HE 120 Be careful not to drop the bobbin, Be sure to insert the bobbin correctly

SE-BrotherE_sgml.book Page 22 Monday, June 30, 2003 3:44 PM

GETTING READY ————————————————————————————————————————————

cHold the bobbin with your right hand and hold the end of the thread with your left.

• Be careful not to drop the bobbin.

dInsert the bobbin into the shuttle so that the thread unrolls to the left.

• Be sure to insert the bobbin correctly.

CAUTION

●Be sure to hold down the bobbin with your finger and unroll the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect.

Memo

zThe order that the bobbin thread should be passed through the shuttle is indicated by marks around the shuttle. Be sure to thread the machine as indicated.

eLightly hold down the bobbin with your right hand, and then guide the thread as shown with your left hand.

fPass the thread through the slot as shown, and then pull the thread out toward the front.

1

aCutter

XThe cutter cuts the thread.

gReattach the bobbin cover.

Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side.

2

1

XThe bobbin threading is finished.

Next, thread the upper thread. Continue with the procedure in "Upper Threading" (on the next page).

Memo

zYou can begin sewing without pulling up the bobbin thread. If you wish to pull up the bobbin thread before starting to sew, pull up the thread according to the procedure in "Pulling up the bobbin thread" (page 33).

22