Brother HE 120 operation manual Winding/Installing the Bobbin

SE-BrotherE_sgml.book Page 19 Monday, June 30, 2003 3:44 PM

————————————————————————————————————————————————————

dPlace the bobbin on the bobbin winder shaft so that the spring on the shaft fits into the notch in the bobbin.

1

2

aNotch

bBobbin winder shaft spring

eSlide the bobbin winder shaft to the right.

fPlace the spool of thread for the bobbin onto the bobbin thread spool pin.

gSlidespoolthepin.spool cap onto the bobbin thread With the rounded side of the spool cap positioned toward the left, slide the spool cap onto the bobbin thread spool pin as far as

possible until the right side of the spool touches 1 the right end of the bobbin thread spool pin.

CAUTION

●Two spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the needle may break.

•Use the special Brother embroidery bobbin thread when embroidering.

Note

zIf a spool of thread 12 mm (1/2 inch) in diameter and 75 mm (3 inch) high is inserted onto the bobbin thread spool pin, use the special spool cap.

2

1

a12 mm (1/2 inch) b 75 mm (3 inch)

Winding/Installing the Bobbin 19