Brother HE 120 Installing the bobbin, Install the bobbin wound with thread, Bobbin cover opens

SE-BrotherE_sgml.book Page 21 Monday, June 30, 2003 3:44 PM

————————————————————————————————————————————————————

XThe bobbin starts spinning and winding the thread, and "Winding bobbin thread..." appears on the LCD.

XWhen winding is complete, the bobbin stops spinning or spins freely.

mWhen the bobbin either stops spinning or spins

freely, press (Start/stop button).

X The sewing machine stops, and the "Winding bobbin thread..." display disappears from the LCD.

nUse scissors to cut the end of the thread wound around the bobbin.

oSlide the bobbin winder shaft to the left.

pRemove the bobbin from the shaft.

qRemove the spool cap and spool.

rSwing down the bobbin thread spool pin, close the bobbin winder cover, and then slide the sewing speed controller back to its original position.

Memo

zWhen the sewing machine is started or the balance wheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction.

Installing the bobbin

Install the bobbin wound with thread.
CAUTION	1

●Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect.

●The bobbin was designed specifically for this sewing machine. If bobbins from older models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB:XA5539- 151).

Actual size

11.5 mm (7/16 inch)

This model Older model

aSlide the bobbin cover latch to the right.

12

aBobbin cover b Latch

XThe bobbin cover opens.

bRemove the bobbin cover.

Winding/Installing the Bobbin 21