EverFocus EDR 410, EDR 810, EDSR 110, 920 Alarm Input / Output Installation, Host PIN # Name

ATTENTION: Some Pelco-D / -P protocol domes and receivers require an address offset of -1. In other words, the address assigned to the dome / receiver in the DVR camera menu must be 1 below the address set in the dome / receiver itself! (i.e. DVR ID: 2, PTZ ID: 3)

2.4Alarm Input / Output Installation

The EDR1640/1620/920 alarm inputs can be used for recording start or recording rate adjustment. Furthermore, alarm reactions such as camera switching to monitors, buzzer, e-mail and network alarm are available. An alarm output relay can be switched if required.

EDR920 provides 9 alarm inputs, EDR1640/1620 provides 16. All inputs are programmable NO/NC.

Inputs have to be switched through dry contacts.

The 4 output relays provide a dry NO/NC contact.

All settings are programmed in the ALARM menu.

Use either the 37-pin Sub-D plug or the included adaptor board for connection.

Pin assignment adaptor board Pin assignment sub-d board

HOST

PIN #	NAME	PIN #	NAME
1	GND	21	GND
2	ALMIN 1	22	ALM_NC1
3	ALMIN 2	23	ALM_NO1
4	ALMIN 3	24	ALM_COM1
5	ALMIN 4	25	ALM_NC2
6	ALMIN 5	26	ALM_NO2
7	GND	27	ALM_COM2
8	ALMIN 6	28	GND
9	ALMIN 7	29	ALM_NC3
10	ALMIN 8	30	ALM_NO3
11	ALMIN 9	31	ALM_COM3
12	ALMIN 10	32	ALM_NC4
13	GND	33	ALM_NO4
14	ALMIN 11	34	ALM_COM4
15	ALMIN 12	35	GND
16	ALMIN 13	36	ALMRST
17	ALMIN 14	37	REC_IN
18	ALMIN 15	38	SPARE_IN
19	ALMIN 16	39	DISK_FULL
20	GND	40	SPARE_OUT

DVR

PIN	NAM	PIN	NAM
#	E	#	E
1	GN	19	GN
	D		D
2	ALM 1	20	ALM-NC0
3	ALM 2	21	ALM- NO
			0
4	ALM 3	22	ALM-COM0
5	ALM 4	23	ALM-NC1
6	ALM 5	24	ALM- NO
			1
7	ALM 6	25	ALM-COM1
8	ALM 7	26	ALM-NC2
9	ALM 8	27	ALM- NO
			2
10	ALM 9	28	ALM-COM2
11	ALM 10	29	ALM-NC3
12	ALM 11	30	ALM- NO
			3
13	ALM 12	31	ALM-COM3
14	ALM 13	32	ALMRSTO
15	ALM 14	33	REC
16	ALM 15	34	GIN1
			O
17	ALM 16	35	DISKFULL
18	GN	36	GO
	D		1

18