EverFocus EDSR 110, EDR 410, EDR 810, 920 instruction manual Motion Area

13.MOTION AREA

Enter a desired channel and press SELECT or middle mouse button to edit a motion area. MOTION must be set as “Enable” in order to edit the motion detection area.

In the motion edit mode:

The default motion area of each camera is entire screen which displays in light green.

Press COPY or left-click the mouse to start setting an area.

Use the JOG Dial to move the cursor. Press

ENTER to switch between vertical and

horizontal movement.

Press SEARCH to end and enable the

area, or press PAUSE to end and disable the area.

Alternatively, right-click the mouse to obtain a selection menu, then use the “+” or “-“ signs to either select “ON” to enable the area or “OFF” to disable the area, then click “OK”.

To quit the motion area edit, press MENU or right-click the mouse to obtain a selection menu, select “EXIT” by clicking the “+” or “-” sign. Then press “OK”.

To test a motion area: Grids will turn from green to red when motion is detected.

To clear the motion entire area: Press PLAY to clear the entire motion area.

If you forget the motion grid commands: Press CALL to display a hint window (shown below).

MENU	- EXIT
COPY	- SELECT AREA
ENTER	- CHANGE DIR
SEARCH	- ON AREA
PAUSE	- OFF AREA

40