The Eltron Company P310 manual Stepper Belt Tension, Stepper Motor Fasteners

CHAPTER 6

6.4.1 Stepper Belt Tension

Three screws fasten the Stepper Motor to the rear chassis casting. For belt tensioning purposes, two of the screws hold the motor through slotted holes. The remaining screw feeds through a non-slotted hole that serves as a pivot point for motor position adjustments. Refer to Figure 6-4, and proceed as follows:

Step 1. Remove the Printer Assembly and its rear plate (see Section 5.2.15).

Step 2. Loosen the three screws holding the Stepper Motor just enough to allow the motor to be repositioned. A half to three-quarter turn should suffice.

Figure 6-4. Stepper Motor Fasteners.

6-6 980264-001 Rev.B