The Eltron Company P310 manual Ribbon Sensor Removal

CHAPTER 5

5.2.8 Ribbon Sensor Removal

The four wires of the Ribbon Sensor connect to the Daughter Board. Refer to Figure 5-12, and proceed as follows:

Step 1. Remove Rear Case, and disconnect the wires from the CPU Board, and if installed, the Encoder Board (see Sections 5.2.1, 5.2.10, and 5.2.11).

Step 2. Remove the Rear Plate with attached circuit boards (see Section 5.2.11).

Step 3. Remove the single screw holding the Ribbon Sensor.

Step 4. Cut the Cable Ties holding the Ribbon Sensor wires.

Step 5. Unplug the Ribbon Sensor Connector from the Daughter Board.

Step 6. Remove the Ribbon Sensor while feeding the associated cable and connector along the routing path.

Figure 5-12. Ribbon Sensor Removal.

5-14 980264-001 Rev.B