Putting the devices into operation

Mounting the diversity receiver to a camera

Use the supplied CA 2 camera adapter to mount the receiver to a camera’s flash mount.

Determine where on the perforated plate  the flash mount adapter  will need to be



 

fastened so that the receiver can best be attached to the camera.

 



 At this position, place a square nut  under the perforated plate .

 

 Fasten the flash mount adapter  to the perforated plate  using the square nut .

 

 

 

 

 Lift one side of the belt clip  as shown.



 



Press down the belt clip  at one fixing point and pull it out of the receiver housing.

Repeat for the other side.

Place the perforated plate  onto the rear of the receiver.

Reinsert the belt clip .

Use one of the supplied line cables to connect the line input of the camera to the socket .



The shield of the line cable serves as the antenna for the second diversity section.

11