
If a problem occurs ...
SK 100/SKM 100/SKP 100 G3
Problem | Possible cause | Possible solution | |
Transmitter cannot be | Lock mode is activated | Deactivate the lock mode (see page 20). | |
operated, “Locked” |
|
| |
appears on the display |
|
| |
panel |
|
| |
No operation indication | Batteries are flat or accupack is flat | Replace the batteries or recharge the accupack | |
|
| (see page 13). | |
No RF signal at the | Transmitter and receiver are not on the | Synchronize the transmitter with the receiver | |
receiver | same channel | (see page 19). | |
|
| Set the transmitter to the same channel as the | |
|
| receiver. | |
| Transmission range is exceeded | Reduce the distance between receiver and | |
|
| transmitter. | |
| RF signal is deactivated (“RF Mute“) | Activate the RF signal (see page 21). | |
RF signal available, | Transmitter is muted (MUTE) | Cancel the muting (see page 21). | |
no audio signal, | Receiver’s squelch threshold is adjusted | Reduce the squelch threshold setting on the | |
“MUTE” appears on the | |||
too high | receiver. | ||
display panel | |||
Transmitter doesn’t transmit a pilot tone | Activate or deactivate the pilot tone transmis- | ||
| |||
|
| sion (see page 25). | |
Audio signal has a high | Transmitter’s sensitivity is adjusted too | Adjust the input sensitivity (see page 25). | |
level of background noise | low/too high |
| |
or is distorted |
|
| |
|
|
|
If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, please contact your local Sennheiser partner for assistance. To find a Sennheiser partner in your country, search at www.sennheiser.com under “Service & Support”.
30