Using the devices

Plugging the plug-on transmitter onto a microphone

Plug the microphone’s XLR-3M socket onto the transmitter’s XLR-3F socket .





Tighten the locking ring  in the direction of the arrow.

The transmitter uses the microphone body as an antenna – therefore microphones with a metal casing should be used for best signal transmission.

Using the devices

To establish a transmission link, proceed as follows:

1.Switch the diversity receiver on.

2.Switch a transmitter on.

The transmission link is established and the diversity receiver’s RF level display “RF” reacts.

If you cannot establish a transmission link between transmitter and diversity receiver:

Make sure that transmitter and diversity receiver are set to the same frequency bank and to the same channel.

If necessary, read the chapter “If a problem occurs ...” on page 29.

It is vital to observe the following notes:

Make sure that the desired frequencies are listed in the enclosed frequency information sheet.

Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

16