Configuring the wireless components

Configuring the wireless components

CAUTION

Risk of violation of legal requirements!

If you are using radio frequencies and transmission powers that cannot be used license-free in your country, there is a risk of violation of legal requirements.

￿Use only radio frequencies and transmission powers that are approved and legal in your country.

￿In the menu bar of the central unit‘s operating menu, click “Wireless Menu” > “Country” and select the correct country/region in which the conference system is to be used (see the ADN system manual).

For wireless conferencing, you have to configure the wireless components in order to adapt the radio settings to the legal requirements of your country and to the requirements of your conference.

For configuring the wireless components, you can either use the central unit’s operating menu or the “Conference Manager” software. However, the full functionality of a wireless conference system can only be configured using the software in “Live” operating mode.

In some countries/regions (e.g. Canada), the use of wireless components operating in the 5.15 to 5.25 GHz frequency band (channel 5 to 8) is restricted to indoor use.

Adjusting the radio settings

1.Select the country/region in which the conference system is to be used (“Wireless Menu” > “Country”).

The conference system only uses the radio settings that are approved and legal in the selected country/region.

2.Select dynamic frequency management (“Wireless Menu” > “Channel Selection” > “Automatic”).

All radio settings are made automatically. The conference system automatically detects occupied frequencies and switches to an unused frequency band in case of interference.

3.Select the access mode for the wireless conference units:

Open access mode (“Wireless Menu” > “Access mode” > “Open”)

All ADN-W D1 wireless conference units that are ready for operation automatically connect to the antenna module and can be used instantly. This access mode should be used if only

12 ADN-W AM