Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1.Switch the diversity receiver on (see next section).
2.Switch a transmitter on (see the instruction manual of the trans- mitter).
The transmission link is established and the receiver’s RF level display “RF” reacts.
It is vital to observe the notes on frequency selection on page 30.
If you cannot establish a transmission link between transmitter and receiver, read the chapter “Synchronizing a transmitter with the receiver” on page 30.
Switching the diversity receiver on/off
Push the two battery compartment catches and open the battery compartment cover .
To switch the diversity receiver on:
The red ON LED lights up and the standard display “Frequency/ Name” appears on the display panel.
To switch the diversity receiver off:
Keep the ON/OFF button pressed until “OFF” appears on the display panel.
The red ON LED goes off and the diversity receiver switches off.
When in the operating menu, pressing the ON/OFF button will cancel your entry (ESC function) and return you to the current standard display.
12