Adjusting settings via the operating menu

Via the “Sync Settings” submenu, you can adjust additional parameters to be transferred to the transmitters (see page 16 and 28).

To transfer these parameters:

￿Switch the transmitter and the diversity receiver on.

￿On the receiver, call up the “Sync” menu item.

“Sync” appears on the display panel of the receiver.

￿Place the infra-red interface of the transmitter (see the instruction manual of the transmitter) in front of the infra-red interface of the receiver ￿.

￿

The parameters are transferred to the transmitter. When the transfer is completed, “” appears on the display panel of the diversity receiver. The receiver then switches back to the current standard display.

To cancel the transfer:

￿Press the ON/OFF button ￿ on the receiver.

“” appears on the display panel of the receiver. “” also appears if:

–no transmitter was found or the transmitter is not compatible,

–no transmitter was found and the synchronization process was canceled after 30 seconds,

–you canceled the transfer.

20