Putting the PXC 360 BT into operation
1
5 
1
1
3s
1
1
5 
6
3
Pairing the PXC 360 BT with your audio source
Make sure that your headphones are switched off (see “Switching the PXC 360 BT on/off” on page 12).
When switching the headphones on for the first time, they will automatically go into pairing mode. The headphones are waiting to be paired with a Bluetooth enabled device (see page 13).
Press the Master button and keep it pressed until the 
LED alternately flashes blue and red.
On your audio source, activate the Bluetooth function “Add a new device”.
Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device identification information. The 
LED flashes 3 times blue and you hear an ascending beep. The devices have identified each other and the headphones are paired with the audio source.
PIN code
When the audio source prompts for a password or PIN code, enter the default PIN code “0000”.
If a connection is established, the
LED continues to slowly flash blue.
If no device is found within approx. 5 minutes, the 
LED flashes 3 times red and you hear a descending beep. The headphones will then try for 3 minutes to connect to one of the up to 8 previously paired audio sources. If this fails, the headphones automatically switch off after 60 minutes.
In this case, repeat the necessary steps to pair the headphones with your audio source again.
Switching the “Bluetooth connection” flashing on/off
Switch the headphones off (see “Switching the PXC 360 BT on/off” on page 12).
To switch the flashing on during a Bluetooth connection:
Press the Master button and keep it pressed until the 
LED alternately flashes blue and red.
Briefly press the Volume button .
To switch the flashing off during a Bluetooth connection:
Briefly press the Volume button .
14