Sennheiser RS 4 Where to place the transmitter, Putting the transmitter into operation, Antenna

Where to place the transmitter

Choose a suitable place near your hi-fi system.

Putting the transmitter into operation
￿	Use the supplied cable to connect socket	on the transmitter to the headphone output socket of your
	hi-fi system. The cable is fitted with a 3.5 mm jack plug suitable for most headphone output sockets.
	For connection to 1/4" (6.3 mm) headphone outputs, use the supplied adaptor.
￿	Connect the plug-in mains unit to socket	on the transmitter and plug the mains unit into a wall socket.

Antenna

The wire antenna is an integral part of the transmitter. For best transmission the antenna should be vertical. You can therefore

￿ leave the wire antenna dangling

in a vertical position down

behind the transmitter - or

￿ (the better option) slide the sup- plied plastic tubing over the an- tenna and snap it into the clamps

at the back of the transmitter:

Make sure that there are no metal objects such as shelf bars or lamp stands in parallel with the antenna. Do not place the transmitter on a TV set as it might interfere with the transmitter. Test where exactly in the room the transmitter works best.

Automatic on/off switching

The transmitter features a convenient automatic on/off function:

￿When an audio signal reaches the transmitter, it is switched on.

￿If there is no audio signal for about 3 minutes, the transmitter automatically switches off. The transmitter is now in stand-by mode, its power consumption is very low so that it can remain connected to the mains.

Important

The transmitter’s charging function (charging compartments ) is independent of the automatic on/off function. Accuplugs can always be recharged when the transmitter is connected to the mains.

16