Putting the SR 2020 D into operation

Putting the SR 2020 D into operation

Connecting the antenna

Preparing the transmitter for use

You can set up the SR 2020 D transmitter on an even surface or mount it into a 19“ rack.

Note:

Do not fit the rubber feet when rack mounting the trans- mitter.

Setting up the transmitter on an even surface

To ensure that the transmitter cannot slip on the surface on which it is placed, four self-adhesive soft rubber feet are supplied.

CAUTION! Risk of staining of furniture surfaces!

Some furniture surfaces have been treated with varnish, polish or synthetics which might cause stains when they come into contact with other synthetics. Despite a thorough testing of the synthetics used by us, we cannot rule out the possibility of staining.

Do not place the transmitter on delicate surfaces.

Ensure that the base of the transmitter is clean and free from grease before mounting the rubber feet.

Fix the rubber feet to the base of the transmitter by peeling of the safety paper and fitting them as shown in the diagram on the left.

Connect the telescopic antenna to the antenna output at the rear of the transmitter.

To obtain the best possible radiation power:

Align the antenna vertically.

9