If problems occur...
Error checklist
Problem | Possible cause | Possible solution |
|
|
|
No operation indication | Batteries are flat or | Replace the batteries or |
| accupack is flat | recharge the accupack |
|
|
|
| No mains connection (EM 300 G2) | Check the connections of the mains unit |
|
|
|
No RF signal | Transmitter and receiver are not on the | Set transmitter and receiver to the |
| same channel | same channel |
|
|
|
| Transmitter is out of range | Check the squelch threshold setting |
|
| (see “Adjusting the squelch threshold |
|
| (EM 300 G2 only)“ on page 31) or |
|
| reduce the distance between |
|
| transmitter and receiving antenna |
|
|
|
RF signal available, no audio | Transmitter is muted (“MUTE”) | Deactivate the muting function |
signal, “MUTE” display appears |
|
|
Receiver’s squelch threshold is adjusted | See “Adjusting the squelch threshold | |
on the display panel | too high | (EM 300 G2 only)” on page 31 |
| ||
|
|
|
| Transmitter doesn’t transmit a | See “Activating/deactivating the pilot |
| pilot tone | tone transmission or pilot tone |
|
| evaluation” on page 33 |
|
|
|
Audio signal has a high level of | Transmitter sensitivity is adjusted too | See “Adjusting the sensitivity |
background noise | low | (transmitters only)” on page 30 |
|
|
|
| Receiver’s AF output level is adjusted | See “Adjusting the audio output level |
| too low | (EM 300 G2 only)” on page 31 |
|
|
|
Audio signal is distorted | Transmitter sensitivity is adjusted too | See “Adjusting the sensitivity |
| high | (transmitters only)” on page 30 |
|
|
|
| Receiver’s AF output level is adjusted | See “Adjusting the audio output level |
| too high | (EM 300 G2 only)” on page 31 |
|
|
|
No access to a certain channel | During scanning, an RF signal has been | See “Scanning the channel banks for |
| detected on this channel and the | free channels (EM 300 G2 only)” on |
| channel has been locked | page 29 |
|
|
|
| During scanning, a transmitter of your | See |
| system operating on this channel has | page 30 |
| not been switched off |
|
|
|
|
If problems occur that are not listed in the above table or if the problems cannot be solved with the proposed solutions, please contact your local Sennheiser agent for assistance.
35