Sentry Industries PT40 Sentry Commander - PT40 Operations 35 Installation and Operations Manual

Displaying Infeed information
The Show Infeeds command displays information about all infeeds. This information includes the
absolute and descriptive infeed names.
To display tower information:
At the Sentry: prompt, type show infeeds and press Enter.
Example
Sentry: show infeeds<Enter>
Input Input
Feed ID Feed Name
.AA HQ_1_Infeed_A
Displaying the Sentry firmware version
The Version command displays the Sentry firmware version.
To display the firmware version:
At the Sentry: prompt, type version and press Enter.
Performing a warm boot
The Restart command performs a warm boot of the Sentry.
NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this command.
To perform a warm boot:
At the Sentry: prompt, type restart and press Enter.
TCP/IP Administration
NOTE: A restart of the Sentry is required after setting or changing ANY TCP/IP configurations. See Performing a warm
boot on page 35 for more information.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Sentry: prompt, type set ipaddress, followed by the IP address and press Enter.
Example
The following command sets the IP address to 12.34.56.78:
Sentry: set ipaddress 12.34.56.78<Enter>
Setting the subnet mask
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.
To set the subnet mask:
At the Sentry: prompt, type set subnet, followed by the subnet mask and press Enter.
Example
The following command sets the subnet mask to 255.0.0.0
Sentry: set subnet 255.0.0.0<Enter>
Setting the gateway
The Set Gateway command sets the IP address of the default gateway the Sentry uses to access external
networks.
To set the gateway IP address:
At the Sentry: prompt, type set gateway, followed by the gateway IP address and press Enter.
Example
The following command set the gateway IP address to 12.34.56.1:
Sentry: set gateway 12.34.56.1<Enter>
Sentry Commander - PT40 Operations • 35
Installation and Operations Manual