Shark EP709T owner manual Full Dust Bag Indicator, Changing the Pre-Motor Filter

OPERATING INSTRUCTIONS

PRECAUTIONARY MEASURES

Full Dust Bag Indicator

The vacuum cleaner has a built-in pressure safety valve. As soon as the dust bag is full or the suction hose is blocked, the dust bag full light will come on. If the suction power is noticeably diminished, first check if the suction hose is blocked. Then check if dust bag is full. If this is the case, change it. We recommend that the dust bag be changed when it is 2/3 full so that full suction can be maintained.

Changing the Pre-Motor Filter

The pre-motor filter is located inside the storage compartment behind the dust bag. (Fig. 6)

Changing the Post Motor

Filter

•Filter should be cleaned at least twice

a year or when it becomes visibly soiled.

•Always operate the cleaner with the post motor filter installed.

•Disconnect from electrical outlet before cleaning the filter.

•Do not use a washing machine to rinse the filter.

•Do not use a hair dryer to dry it.

•Always allow 24 hours to air dry.

1.Remove the post motor filter cover that is located the rear of the unit. (Fig. 8)

Important: If the suction opening of the unit, the hose or the extension tubes are BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.

1. Do not operate the vacuum	4. When pulling out the power plug
cleaner too close to heaters or	from the wall outlet, pull the plug
radiators.	not the power cord.

•The pre-motor filter should be cleaned at least twice a year or when it becomes visibly soiled.

•Always operate the cleaner with the filter installed.

•Disconnect from electrical outlet before cleaning the filter.

•Do not use a washing machine to rinse the filter.

•Do not use a hair dryer to dry it.

•Always allow 24 hours to air dry.

1.Press the storage compartment release button and open the cover.

2.Remove the paper bag from the unit.

3.Pull the pre-motor filter assembly out of the unit.

4.Remove the pre-motor filter from the filter grill.

5.Rinse the pre-motor filter in lukewarm water and let the pre-motor filter air dry for 24 hours until it is completely dry. (Fig. 7)

6.Replace the pre-motor filter into the filter grill and replace back into the unit.

7.Replace the dust bag and close the storage compartment cover.

Pre-motor

filter

Fig. 6

Fig. 7

Fig. 8

2.Remove the post motor filter from the filter grill. (Fig. 9)

3.Rinse the post motor filter in lukewarm water and let the post motor filter air dry for 24 hours until it is completely dry. (Fig. 10)

4.Replace the post -motor filter into the filter grill and replace back into the unit.

Fig. 9

Fig. 10

2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.

3.Before you start vacuuming, make sure to remove large or sharp objects that might damage the dust bag.

5.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.

6.Do not use without all filters and dust bag in place.

Note: This vacuum cleaner is equipped with a plug and power cord that retract automatically. If the cord or plug get damaged, it must be replaced by a qualified technician.

Warning: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.

6

3