Sharp 25N M180 VCR POWER, DISPLAY , REMOTE KEYPAD

34
1 2 3
4 5 6
7 8 9
0 100
POWER
TV
VCR
MENU MUTE
CATV
PAUSE
TV
FLASHBACK
A
DISPLAY INPUT
BCD
STOP REC
REW PLAY FF
VCR CH
ENTER
PERSONAL PREFERENCE
VOL
—
CH
CH
VOL
+
Operation of Remote Control (Continued)
LHOW TO IDENTIFY A VCR
The remote control may already be set to
operate your VCR. Try this initial check to see
if going on to the following “identify” section is
necessary.
(1) Point remote towards VCR and press VCR
POWER .
(2) Does the remote turn the VCR ON and OFF?
•If yes, the remote is ready to operate the VCR
and no further steps are needed.
•If no, continue to the “identify” section.
LTo Identify Your VCR – Direct Entry Method.
Use the following steps and list to quickly
find the remote control code for your
accessory VCR.
•First look up your VCR’s remote control code
number before going through the direct code
entry steps control.
•If this procedure does not identify your
accessory VCR, use the Search method of
identification (described in the next section).
(1) Slide TV-CATV switch to TV.
(2) Press and hold down DISPLAY and
CH DOWN ( 9 ) on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing DISPLAY
and CH DOWN ( 9 ) , enter your VCR’s two-
digit remote control code number using
REMOTE KEYPAD (refer to list).
•The remote control is now ready to send
commands to your VCR.
Some brands have more than one remote
code listed, due to changes in the remote
codes from early to later model years, or due
to format differences (VHS/BETA). In such
cases, you may have to try more than one code
to find the code your VCR accepts.
NOTE:
Depending on the model, year produced,
brand, and type of VCR, some models may
not be compatible with the remote control.
LTo Identify Your VCR – Search Method.
(1) Slide
TV-CATV switch on the remote to TV.
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of
the VCR.
Point the remote towards the VCR.
Hold down DISPLAY and CH UP ( 8 ) at the
same time. KEEP HOLDING THE BUTTONS
DOWN.
(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when
the VCR has been identified.
Release DISPLAY and CH UP ( 8 ) as soon
as the channel numbers start to scan up.
The VCR’s remote control code number has
been identified, and the remote is ready to
operate the VCR.
VCR
POWER
DISPLAY
REMOTE
KEYPAD
CHANNEL
UP(8)/
DOWN(9)
TV-CATV
33-40/25N-M180 w/Imp. Safe 6/6/00, 9:44 AM34