Sharp 32C530 Outdoor Antenna Connection, Combination VHF/UHF Antennas Separate VHF/UHF Antenna

Antenna Connections (Continued)

OUTDOOR ANTENNA CONNECTION

•Refer to one of the following two diagrams when connecting to an outdoor antenna.

A:Using a VHF/UHF combination outdoor antenna.

B:Using separate VHF and/or UHF outdoor antenna.

•Connect an outdoor antenna cable lead-in to the ANT/CABLE terminal on the rear of the TV set.

A. Combination VHF/UHF Antennas		B. Separate VHF/UHF Antenna
	VHF/UHF ANTENNA		REAR PANEL
	300/75-ohm
VHF/UHF ANTENNA	ADAPTOR
	(Not supplied)
or	300-ohm	VHF	UHF
	twin-lead
		ANTENNA ANTENNA
			300-ohm
			twin-lead
75-ohm			COMBINER
			300-ohm (not supplied)
coaxial cable
			twin-lead
			IN OUT
		or	75-ohm coaxial
			cable

REAR PANEL

NOTICE

F-type connector should be finger-tightened only.

F-type connector

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV

set.

(The breaking of internal circuit, etc.)

75-ohm coaxial cable

CABLE TV (CATV) CONNECTION

•A 75 ohm coaxial cable connector is built into the set for easy hookup. When connecting the 75 ohm coaxial cable to the set, screw the 75 ohm cable to the COAXIAL CABLE CONNECTOR.

•Some cable TV companies offer “premium pay channels”. Since the signals of these premium pay channels are scrambled, a cable TV converter/descrambler is generally provided to the subscriber by the cable TV company. This converter/descrambler is necessary for normal viewing of the scrambled channels. (Set your TV on channel 3 or 4. Typically one of these channels is used. If this is unknown, consult your cable TV company.) For more specific instructions on installing cable TV, consult your cable TV company. One possible method of utilizing the converter/descrambler provided by your cable TV company is explained below.

Please note: RF switch equipped with position A/B (not provided) is required.

“A” position on the RF switch (not supplied) : You can view all unscrambled channels using the TV’s channel keys.

“B” position on the RF switch (not supplied) : You can view the scrambled channels via the converter/ descrambler using the converter’s channel keys.

RF switch (not supplied)

Two-set

A signal

OUT IN		splitter	Cable TV Line
B	IN	(not
OUT		supplied)

Cable TV converter/

descrambler (not supplied)

Note:

•Consult your SHARP Dealer or Service Center for the type of splitter, RF switch or combiner that might be required.

6

27C530(05-06) 6 1/29/03, 1:47 PM

Dimension: 140mm x 215mm