Sharp BD-HP17U Before Starting Playback, Loading the Batteries in the Remote Control

Disc Playback

Before Starting Playback

Loading the Batteries in the Remote Control

1Hold in the tab on the battery cover and pull the cover towards the direction of the arrow.

Approximate operating range of remote control

Remote control sensor

2Load the two “AA” size batteries (R-06 size,

UM/SUM-3). Place batteries with their terminals corresponding to the m and n indications in battery compartment.

30º 30º

7 m

Remote control unit

3Insert the smaller tab of the battery cover into the opening 1, and press down on the cover until it clicks in place 2.

NOTE

•Do not subject the remote control unit to shock, water or excessive humidity.

•The remote control unit may not function if the Player's remote sensor is in direct sunlight or any other strong light.

•Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly.

•Do not mix old and new batteries, or mix different brands.

•Remove the batteries if you will not use the remote control unit for an extended period of time.

Connecting the Power Cord

Plug the supplied AC cord into the AC IN terminal on the rear of the Player. Then plug into AC outlet.

To AC IN terminal

To AC outlet

NOTE

•Place the Player close to the AC outlet, and keep the power plug within reach.

•TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD IS CONNECTED.

•The ON/STANDBY indicator blinks while the Player is preparing for starting up. You cannot turn the Player on until the ON/STANDBY indicator stops blinking.

•If you are not going to use this Player for a long period of time, be sure to remove the AC cord from the AC outlet.

Disc Playback

19