Sharp BD-HP17U operation manual Option, Press c/d to select Complete, then press

SETTINGS

10Select “Next”, then press ENTER.

11For the advanced setting (the setting of the Ethernet connection speeds), press c/d to select “Yes” or “No”, then press ENTER.

•Normally select “No”, then press ENTER.

•The Ethernet connection speeds can be set when you select “Yes”, then press ENTER.

•As automatic detection is made (factory preset mode), this setting is not normally necessary. If a situation occurs in which the Ethernet connection fails, etc., change the setting and confirm if the Ethernet connection successfully works.

When the connection speed is set, select “Next”, then press ENTER.

Option

Ethernet Connection Speeds

Yes

Auto-Detection

10M Half Duplex

100M Half Duplex

Next

No

10M Full Duplex

100M Full Duplex

12For testing the connection to the internet, after confirming the settings, press c/d to select “Test”, then press ENTER.

•“Test” is available only when setting to obtain the IP address automatically. “Test” cannot be selected if the IP address has not been obtained automatically.

Confirm the current setting.

IP Address	: xxx xxx xxx xxx
Netmask	: xxx xxx xxx xxx
Gateway	: xxx xxx xxx xxx

DNS Address : xxx xxx xxx xxx

MAC Address : xx:xx:xx:xx:xx:xx

Test

Complete

•As a result of the test, if the internet connection fails, enter the setup values manually.

13Press c/d to select “Complete”, then press

ENTER.

40