Sharp CD-DH790NH operation manual Timer and sleep operation Remote control only, Timer playback

Timer and sleep operation (Remote control only)

CD

USB

Timer playback:

The unit turns on and plays the desired source (CD, TUNER, USB, iPod, AUDIO IN, TAPE) at a preset time.

This unit has 2 types of timer: ONCE TIMER and DAILY TIMER.

Once timer:

Once timer play works for one time only at a preset time.

Daily timer:

Daily timer play works at the same preset time every day. For example, set the timer as a wake-up call every morning.

Using the once timer and daily timer in combination: For example, use the once timer to listen a radio programme, and use the daily timer to wake up.

1Set the daily timer (pages 21 - 22).

2Set the once timer (pages 21 - 22).

1 minute or more

Daily timer Once timer

Start Stop Start Stop

■Timer playback

Before setting timer:

●Check that the clock is set to the correct time (refer to page 8). If it is not set, you cannot use the timer function.

●For timer playback: Plug in USB or load discs or dock iPod to be played.

1Press the ON/STAND-BY button to turn the power on.

2Press and hold the CLOCK/TIMER button.

3Within 10 seconds, press the or button to select “ONCE SET” or “DAILY SET”, and press the MEMORY button. Set the clock to the correct time if “ONCE SET” or “DAILY SET” does not appear.

4Within 10 seconds, press the or button to select “TIMER SET”, and press the MEMORY button.

5To adjust the hour, press the or button and then press the MEMORY button.

6To adjust the minutes, press the or button and then press the MEMORY button.

7Set the time to finish as in steps 5 and 6 above.

8To select the timer playback source (CD, TUNER, USB,

iPod, TAPE or AUDIO IN), press the or button. Press the MEMORY button.

When you select the tuner, select a station by pressing

the or button, and then press the MEMORY button. If a station has not been programmed, “NO PRESET” will be displayed and timer setting will be cancelled.

9Adjust the volume using the VOLUME control, and then press the MEMORY button. Do not turn the volume up too high.

10Press the ON/STAND-BY button to enter the power stand-by mode. The “TIMER” indicator lights up and the unit is ready for timer playback.

MINI COMPONENT SYSTEM

FUNCTION

ON/STAND-BY

VOL

PUSH

OPEN

11 When the preset time is reached, playback will start. The volume will increase gradually until it reaches the preset volume. The “ ” indicator will blink during timer playback.

The “DAILY” indicator will blink during timer playback.

21