Sharp CD-DH790NH Listening to the iPod continued, To insert iPod adaptor, To remove iPod adaptor

Listening to the iPod (continued)

■To insert iPod adaptor

1Press the ON/STAND-BY button to turn the power on.

2Insert the iPod adaptor into the iPod dock and connect your iPod.

iPod (bottom)

iPod

Dock connector

iPod adaptor

iPod dock

iPod connector

■To remove iPod adaptor

Insert the tip of a screwdriver (“–” type, small) into the iPod adaptor hole as shown and lift upward to remove.

MINI COMPONENT SYSTEM

ON/STAND-BYFUNCTION

ON/STAND-BY

VOL

CD

USB

■iPod playback

1Press the ON/STAND-BY button to turn the power on.

2Press the iPod button on the remote control or FUNCTION button repeatedly on the main unit to select iPod function.

3Insert iPod unit in iPod dock of main unit.

4Press the / button to start playback.

■To disconnect iPod

Simply remove the iPod from the iPod dock. It is safe to do so even during playback.

■Navigating the iPod menus

1Press the MENU button to view the menu on iPod unit. Press it again to go back to previous menu.

2Use the TUNING ( or ) button on the remote control to select an item on the menu and then press ENTER button.

Note:

When navigating the iPod menus with remote control, do not operate any of the buttons on the iPod unit. The volume level is adjusted by pressing the VOL (+ or –) button on the main unit or the remote control. Adjusting the volume on the iPod unit gives no effect.

iPod operation:

The operations described below depend on the generation iPod you are using.

System on operation:

When the main unit is powered on, the iPod unit will automatically power on when docked in the unit (including TIMER function/exclude USB function).

System off (stand-by operation):

When the main unit is turned to stand-by mode, the docked iPod unit will automatically turn to stand-by mode.

9