Sharp CD-DH790NH Remote control, General control, Battery installation, To turn the power on

Remote control

■Battery installation

Use 2 “AAA” size batteries (UM-4, R03, HP-16 or similar). Batteries are not included.

1Open the battery cover.

2Insert the batteries according to the direction indicated in the battery compartment.

When inserting or removing the batteries, push them towards the (–) battery terminals.

3Close the cover.

Caution:

●Replace all old batteries with new ones at the same time.

●Do not mix old and new batteries.

●Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.

●Do not use rechargeable batteries (nickel-cadmium battery, etc.).

●Installing the batteries incorrectly may cause the unit to malfunction.

●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

Notes concerning use:

●Replace the batteries if the operating distance is reduced or if the operation becomes erratic.

●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

●Keep the remote control away from moisture, heat, shock, and vibrations.

■Test of the remote control

Check the remote control after checking all the connections.

Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below:

Remote sensor

MINI COMPONENT SYSTEM

FUNCTION

ON/STAND-BY

VOL

0.2 m - 6 m

(8" - 20')

PUSH

OPEN

AUDIOIN

PHONES

General control

MINI COMPONENT SYSTEM

ON/STAND-BY

CD

USB

■To turn the power on

Press the ON/STAND-BY button to turn the power on.

After use:

Press the ON/STAND-BY button to enter the power stand-by mode.

■Display brightness control

To dim the display brightness, hold down the CLEAR/DIMMER button on the remote control for 2 seconds or more.

■Volume auto fade-in

If you turn off and on the main unit with the volume set to 27 or higher, the volume starts at 16 and fades in to the last set level.

■Volume control

Turn the volume knob towards VOL +/– (on main unit) or press VOLUME +/– (on remote control) to increase or decrease the volume.

■X-Bass control

When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and “X-BASS” will appear. To cancel the extra bass mode, press the X-BASS button on the remote control.

■Bass control

1Press the BASS/TREBLE button to select “BASS”.

2Within 5 seconds, press the VOLUME (+ or –) button to adjust the bass.

■Treble control

1Press the BASS/TREBLE button to select “TREBLE”.

2Within 5 seconds, press the VOLUME (+ or –) button to adjust the treble.

■Equaliser

When the EQUALIZER MODE button is pressed, the current mode setting will be displayed. To change to a different mode, press the EQUALIZER MODE button repeatedly until the desired sound mode appears.

FLAT	NoNoeequalisationlization. .
GAME	For game.
	For rock music.
CLASSIC	For	music.
	For clclassicalsical music.
POPS	For	music.
	For ppop music.
VOCAL	VocalsVocals arereenhancedenhanced. .
JAZZ	For .
	For jajazz.

7