Listening to the radio
■Tuning
1� Press the
select FM Stereo, FM Mono or AM.
3� Press the TUNING (
or 
) button on main unit or remote control to tune in to the desired station.
●Manual tuning:
Press the TUNING (
or 
) button repeatedly to tune in to the desired station.
●Auto tuning:
When the TUNING (
or 
) button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
●When radio interference occurs, auto scan tuning may stop automatically at that point.
●Auto scan tuning will skip weak signal stations.
●To stop the auto tuning, press the TUNING (
or 
) button again.
●When an RDS (Radio Data System) station is tuned in, the frequency will be displayed first, and then the RDS indicator will light up. Finally, the station name will appear.
●Full auto tuning can be achieved for RDS stations “ASPM”, see page 16.
To receive an FM stereo transmission:
●Press the TUNER button to select stereo mode and “ST” indicator will be displayed. “
” and “
” will appear when an FM broadcast is in stereo.
●If the FM reception is weak, press the TUNER button to extinguish the “ST” indicator.The reception changes to monaural, and the sound becomes clearer.
■Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a button. (Preset tuning)
1� Perform steps 2 - 3 in “Tuning”.
2� Press the MEMORY button.
3� Within 30 seconds, press the PRESET (
or 
) button to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1.
4� Within 30 seconds, press the MEMORY button to store that station in memory. If the “MEMORY” and preset number indicators disappear before the station is memorised, repeat the operation from step 2.
5� Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in the memory, the station previously memorised for that preset channel number will be erased.
Note:
The backup function protects the memorised stations for a few hours should there be a power failure or the AC power lead becomes disconnected.
■To recall a memorised station
Press the PRESET (
or 
) button for less than 0.5 seconds to select the desired station.
■To scan the preset stations
The stations saved in the memory can be scanned automatically. (Preset memory scan)
1� Press the PRESET (
or 
) button for more than
0.5seconds. The preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each.
2� Press the PRESET (
or 
) button again when the desired station is located.
■To erase entire preset memory
1� Press the FUNCTION button (main unit) repeatedly or TUNER button (remote control) to select Tuner function.
2� In Tuner function, press the CLEAR button until “Tuner Clear” appears.
15
