General control

To turn the power on

Press the ON/STAND-BY button to turn the power on.

After use:

Press the ON/STAND-BY button to enter the power stand- by mode.

Display brightness control

To dim the display brightness, press the DIMMER button on the remote control.

Dimmer 1 (Display is dim). Dimmer 2 (Display gets dimmer). Dimmer Off (Display is bright).

Volume auto fade-in

If you turn off and on the main unit with the volume set to 27 or higher, the volume starts at 12 and fades in to the last set level.

Volume control

Press VOLUME (+ or -) on the main unit or VOL +/- on the remote control to increase or decrease the volume.

Direct key power on function

When you press any of the following buttons, the unit turns on.

iPod, CD/USB, AUDIO IN, TUNER on the remote control: Selected function is activated.

/ button on the main unit: The unit turns on and playback of the last function will start (CD, TUNER, USB, iPod, AUDIO IN)

Auto power off function

The main unit will enter the stand-by mode (when iPad, iPod or iPhone is not connected) after 15 minutes of inactivity during:

iPod: Not docked.

Audio In: No detection of input signal.

CD:

In the stop mode or no disc.

USB:

In the stop mode or no media.

Note:

However, if iPod or iPhone is docked, the unit will begin charging.

“Charge Mode” will be displayed.

Muting

The volume is muted temporarily when pressing the MUTE button on the remote control. Press again to restore the volume.

X-Bass control

When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and “X-BASS” indicator will appear. To cancel the extra bass mode, press the X-BASS button on the remote control.

Bass control

1Press the BASS/TREBLE button to select “Bass”.

2Within 5 seconds, press the VOLUME (+ or –) button to adjust the bass. “X-BASS” indicator will disappear.

- 5 - 4........↔ + 4 ↔ + 5

Treble control

1Press the BASS/TREBLE button to select “Treble”.

2Within 5 seconds, press the VOLUME (+ or –) button to adjust the treble. “X-BASS” indicator will disappear.

- 5 - 4........↔ + 4 ↔ + 5

Function

When the FUNCTION button on main unit is pressed, the current function will change to different mode. Press the FUNCTION button repeatedly to select desired function.

CD FM STEREO FM MONO

AM

Audio In iPod USB

Note:

The backup function will protect the memorised function mode for a few hours should there be a power failure or the AC power lead becomes disconnected.



Page 8
Image 8
Sharp DK-KP82PH operation manual General control