Installation Manual

For 3 & 4-Wire Permanent Connections

terminal

 

block

 

line 1

line 2

neutral

ground strap

 

ground plate

 

ground

 

screw

Figure 11

Anti-Tip

NORMAL INSTALLATION STEPS

Anti-Tip bracket Installation Instructions Important Safety Warning

To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed Anti-Tip bracket and screws packed with the range. Failure to install the Anti-Tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it. Serious injury might result from spilled hot liquids or from the range itself.

If range is ever moved to a different location, the Anti-Tip bracket must also be moved and installed with the range. Instructions are provided for installation in wood or cement fastened to either the floor or wall. When installed to the wall, make sure that screws completely penetrate dry wall and are secured in wood or metal. When fastening to the floor or wall, be sure that screws do not penetrate electrical wiring or plumbing.

Figure 13A
4-Wire Permanent Connection only

ground

 

plate

proper ground

 

 

for 4-wire

ground

permanent

screw

ground

 

 

wire lead

Figure 12

ALocate the bracket - Using the Template

The bracket may be located on either the left or right side of the range. Refer to figure 13B to locate the bracket if template is not available.

Figure 13B

Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1 1/4-inches from wall when installed, you may use the wall or floor mount method. See Figure 14. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor. For wall mount, locate the bracket by placing the back edge of the template against the rear wall and the side edge of template on the mark made referencing the side of the range. Place bracket on top of template and mark location of the screw holes in wall. If rear of range is further than 1 1/4-inches from the wall when installed, attach bracket to the floor. See Figure 15. For floor mount, locate the bracket by placing back edge of the template where the rear of the range will be located. Mark the location of the screw holes, shown in template.