Sharp EP703C Apprenez À Connaître Votre Aspirateur, Léger À Traineau, 8 11 9, Motor Thermostat

APPRENEZ À CONNAÎTRE VOTRE ASPIRATEUR

OPERATING INSTRUCTIONS

LÉGER À TRAINEAU

1.Tuyau flexible

2.	Brosse à épousseter		1
3.	Suceur plat
4.	Brosse turbo entraînée par		2
	air	17
5.	Bouton de dégagement du
	tuyau	16
6.	Sac à poussière
7.	Lumière indicatrice du sac à		3
	poussière

8.Bouton de rembobinage de cordon

Cleaning the Pre-Motor Filter

The white polyfoam pre-motor filter is located inside the main unit, behind the dust bag.

1.Open the vacuum cover and pull the filter straight up and out of the vacuum.

2.Wash the filter and allow to air dry for 24 hours.

3.Slide a clean filter into position between the two posts and the motor intake. (Fig. 18)

Flat & Upright Parking Position

Please note that your vacuum cleaner can be conveniently placed in a space saving vertical parking position or in a flat parking position.

1.For vertical parking, place the main unit in the upright position as shown in Fig. 22.

2.For horizontal parking position, place the vacuum flat on its 3 wheels and slide the floor brush into locking position with the receptacle which rests on the rear of the unit. (Fig. 23 & 24)

9.	Poignée de transport		15
10.	Bouton marche/arrêt			4
11.	Brosse à plancher et tapis
12.	Unité principale
13.	Tuyau d’extension inférieur	14
14.	Chariot d’accessoires			5
15.	Tuyau d’extension supérieur
16.	Tube courbé/Extension du		13	6
	tuyau
				12
17.	Contrôle manuel de la succion
				7

8

11

9

10

Les illustrations peuvent différer du produit exact.

Spécifications Techniques

Voltage: 120V. 60Hz.

Puissance: 10 Ampères

Fig. 18

Replacing the Post Motor Filter

The white polyfoam post-motor filter is located at the rear of the main unit.

1.Press down on the post-motor filter door release button and remove the post-motor filter door. (Fig. 19 & 20)

Post-Motor Filter Door

Release Button

Fig. 19 Fig. 20

2. Remove the filter. (Fig. 21)

Fig. 21

3.Wash the filter and allow it to air dry it for 24 hours. Then re-insert the filter and close the post-motor filter door.

Fig. 22

Receptacle

Fig. 23

Fig. 24

Motor Thermostat

Important: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:

•Push the On/Off button once. Disconnect the plug from the power source.

•Check the source of overheating problem. (i.e. clogged hose or filter)

•If clogged hose or filter is found, unclog the hose and replace the filters.

•Wait at least 45 minutes before attempting to reuse the vacuum.

•After unit has cooled down for 45 minutes, plug in the cleaner and push the On/Off button. The vacuum should start again.

•If the vacuum still does not start, contact customer service at 1(800) 798-7398.

23 8