Loading the Imaging Film
17
1. Installation
6Pull the empty spool toward the back
of the compartment, unwinding the
film as you pull.
5Cut the band which holds the spools
together with scissors, and remov e it.
Insert the remaining gear into the
right end of the empty spool and the
flange into the left end of the empty
spool. Make sure the tabs on the gear
and the flange fit into the slots in the
ends of the spool (the gear has two
tabs and the flange has one tab).
7Insert the empty spool into the back
of the compartment so that the gear
and the flange fit into the slots on th e
sides of the compartment.
•Make sure that the gear engages
with the gear below it.
1 tab
2 tabs
Flange
Gear
8Wind the film sl ightly (rota te the gear
on the right side of the empty spool)
so that there is no slack in the film.
Make sure that both edges of the film
wind onto the spool evenly.
all-ux510A.book Page 17 Thursday, September 14, 2000 9:05 AM