Sharp FP-N60CX Main Unit Operation, AUTO operation, Stop, SILENT operation, E-14, Auto

OPERATION

For the first 30 seconds after the power plug is in- serted into the wall outlet, the unit will check the condition of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash green, orange and red.

MAIN UNIT OPERATION

Main Unit Controls

• AUTO

• SILENT

• MEDIUM

• HIGH

• MAX

• POLLEN

Plasmacluster Indicator Light

AUTO

SILENT	MED	HIGH MAX
	OFF TIMER

POLLEN h

FILTERPlasmacluster

CLEAN-SIGN

MODE-ON / OFF Button

The unit will start operating when the MODE-ON / OFF Button is pressed.

The unit will begin operating in the AUTO Mode. (fan level)

• While operating the Plasmacluster Indicator Light will be on.

To switch operating controls, press the MODE-ON / OFF Button until the desired control is activated. (Your desired control will have its Indicator Light lit.)

For the best results of the room environment, set your operation control as desired.

AUTO operation

The fan level is automatically switched (HIGH, MEDIUM, SI- LENT) depending on the amount of impurities in the air. The sensors detect the impu- rities for efficient air purifica- tion.

Stop

POLLEN mode operation

The unit will operate at High level for 10 minutes, then will alternate be- tween MEDIUM and HIGH.

10 minutes: High fan level20 minutes: Medium fan level20 minutes: High fan level

SILENT operation

The unit will operate quietly using minimal air intake.

MEDIUM to MAX operation

The unit will operate at a fan level of MEDIUM, HIGH or MAX.

E-14