|
|
| Operations available with | |
|
|
| the Remote Control | |
|
|
| • AUTO | |
|
|
| • MANUAL | |
|
|
| • POLLEN | |
| REMOTE CONTROL OPERATION |
| • OFF TIMER | |
|
| • DISPLAY ON/OFF | ||
|
| |||
• When you press the POWER ON/OFF Button, a short beep will | Plasmacluster ion mode |
| ||
selections |
| |||
| sound and operation will start. As the initial operation mode, it | • AUTO |
| |
| automatically goes to the AUTO (Fan level) and AUTO |
| ||
| • CLEAN |
| ||
| Plasmacluster ion Mode. |
| ||
| • ION CONTROL |
| ||
• To stop operation, press the POWER ON/OFF Button again. | • OFF |
| ||
| A long beep will sound and operation will stop. |
|
| |
POWER ON/OFF Button
Used to start AUTO operation of the unit. A short beep will signal that the unit is on and a long beep means that the unit is off.
Auto (Fan Level) Button
The fan level switches auto- matically depending on the amount of impurities in the air.
Manual (Fan Level) Button
The fan level can be switched between Silent, Medium, High and Max.
Display ON/OFF Button
Switches the Plasmacluster Indicator Light and CLEAN- SIGN Light either ON or OFF.
•The Plasmacluster Indicator Light is turned on for about 3 seconds by pressing the Plasmacluster Ion Select Button (except for the OFF Button) during “Display OFF” mode.
POWER ON/OFF | FILTER RESET |
Fan Control
OFF
AUTO MANUAL POLLEN TIMER
DISPLAY
ON/OFF
Plasmacluster
CLEAN
AUTO OFF
IONCONTROL
Transmitter
Filter Reset Button
When you have cleaned the Washable Active Carbon Filter and
Pollen Mode Operation Button
The unit operates effectively when you suspect there is pol- len in the air. See Page
Off Timer Button
Used to set the Off Timer.
The set time switches every time the button is pressed as shown below.
1 hour |
| 4 hours |
|
|
|
Cancel |
| 8 hours |
•The indicator light shows the re- maining time.
•The unit will cease operating when the timer is up.
ENGLISH
Plasmacluster Ion mode Selections
Auto
When pressed, the unit will switch between Clean Mode and the Ion Control Mode auto- matically depending on the amount of impuri- ties in the air as detected by the dust and odor sensors. Clean Mode will operate for about 1 minute when the Auto function is selected.
Clean
When pressed, the unit will con- stantly operate in the Clean Mode, in which the same numbers of posi- tive and negative ions are dis- charged. (The Plasmacluster Indi- cator Light is blue.)
Ion Control
When pressed, the unit will constantly oper- ate in Ion Control Mode.
Ion balance is maintained in the room envi- ronment by increasing the ratio of negative ions. (The Plasmacluster Indicator Light is green)
Off
The generation of ions will cease and the Plasmacluster Indicator Light will go out.
If the room is damp or has a mold problem, operate the unit in Clean Mode.
