Sharp GX-BT3 Connecting other equipment, Troubleshooting chart, NFC / Bluetooth,  Condensation

Connecting other equipment

Listening to the playback sounds of portable audio player, etc.

GX-BT3

Portable audio player, etc.

Audio cable (not supplied)

1 Use a connection lead to plug in the portable audio player, etc. to the AUDIO IN socket. When using video equipment, plug in the audio output to this unit and the video output to a television.

2 Press the ON/STAND-BY button to turn the power on.

3 Press the AUDIO IN button on the remote control or FUNCTION button repeatedly on the main unit to select AUDIO IN function.

4 Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.

Note:

To prevent noise interference, place the unit away from the television.

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service technician.

If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre.

General

Symptom Possible cause

When a button is  Set the unit to the power

pressed, the unit	stand-by mode and then
does not respond.	turn it back on.

If the unit still malfunctions, reset it. (Refer page 10)

No sound is heard.  The volume level is set to minimum.

Remote control

Symptom Possible cause

The remote control  The AC power lead of the

does not operate.	unit is not plugged in.
	 The batteries are
	exhausted.
	 The distance or angle is
	incorrect.
	 The remote control sensor
	receives strong light.

■ NFC / Bluetooth

Symptom	Possible cause
● No sound is heard.	● The unit is too far from the
	Bluetooth stereo audio
	source device.
	● The unit is not paired
	with the Bluetooth stereo
	audio source device.
● Bluetooth sound	● The unit is too near to
is interrupted or	a device that generates
distorted.	electromagnetic radiation.
	● There is an obstacle
	between the unit and the
	Bluetooth stereo audio
	source device.
● NFC-enabled device	● Main unit is not in
cannot connect to	Bluetooth pairing mode.
Bluetooth via NFC tag.	Perform “NFC connection
	for audio playback”.
	(Refer page 6.)
 Condensation

Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet or on the transmitter on the remote control. Condensation can cause the unit to malfunction. If this happens, leave the power on until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter with a soft cloth before operating the unit.

E-