Sharp GX-M10H(RD), GX-M10H(OR) System connections, „AC power connection, „DC power connection

System connections

Do not connect the DC or AC power to the unit at the same time.

Wall socket

AC 110 - 240 V ~ 50/60 Hz

To DC IN 12 V socket

To AC INPUT

socket

Car adaptor (not supplied)

Socket: DC 12 V 4.5 A

„AC power connection

After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket.

Notes:

z Remove all batteries when using AC power.

z Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time.

„DC power connection

Caution:

z During battery/DC operation, the unit will be set to Demo mode off with display and subwoofer light in MODE 2 to reduce the

1 2

3

5 4

8 9

10

6 7

battery power consumption.

z When using battery/DC power, the remote control cannot be used to turn on the unit.

z Unplug the AC power lead from the unit before using the DC power. Otherwise the unit will not work.

z Use only a car adaptor with DC 12V output voltage. z Insert the plugs firmly.

z When the unit is not in use for an extended period, remove the car adaptor from the car supply socket.

3 Replace the battery compartment cover. Precautions for battery use:

z Insert the batteries according to the direction indicated on the rear panel.

z Remove the batteries if they are weak or if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage.

z Replace all old batteries with new ones at the same time. z Do not mix old and new batteries.

Black

12V	Red
24V

Attention: connection of DC lead and battery terminals.

: Connect the red battery clip to (+) on the battery terminal.

: Connect the black battery clip to (–) on the battery terminal.

DC power can only be used for a 12V battery.

Do not use any battery besides a 12V.

Battery replacement:

z When batteries are low, battery indicator “” will blink to show that the batteries need to be replaced. sound may become distorted and unit may automatically turn off or mute during high volume level. Reduce the volume level or replace the batteries. z When replacing the batteries, place the unit on a cushion or soft

cloth to avoid damage.

Cautions:

z Do not use rechargeable battery (nickel-cadmium battery, etc.). z Immediately remove the discharged batteries. If the chemical

leak into the unit, clean it.

z Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

„Operation with batteries

1Disconnect the AC and DC power lead, and remove the battery compartment cover.

z Connection of the AC or DC power lead to the unit disconnects the batteries.

2Insert 10 „D” size batteries (UM/SUM-1, R20, HP-2 or similar) into the battery compartment.

z When inserting or removing the batteries 5and 0, push them towards the (-) battery terminals.

z Installing the batteries incorrectly may cause the unit to malfunction. z Batteries are not included.

„Demonstration mode

z The first time the unit is plugged in with AC power, the unit will enter the demonstration mode. You will see words scroll and the subwoofer light up will operate in the flashing mode.

z To cancel the demonstration mode, press the DEMO/DIMMER button (remote control) during power stand-by mode. The unit will enter the low power consumption mode. The subwoofer light will be off.

z To return to the demonstration mode, press the DEMO/DIMMER button again.

z If iPod or iPhone is docked, the unit will begin charging. “iPod CHARGING” will be displayed.

4